#SONY AUDIO TUNER FLASHING PROTECT MANUAL#
#SONY AUDIO TUNER FLASHING PROTECT PLUS#
#SONY AUDIO TUNER FLASHING PROTECT SERIES#

Good luck and feel free to message me with questions. There are plugs too without battery back up and they do support voltage regulation as well. It is best to shut it all down at that point since the battery can only last for a short amount of time depending on how much you have on the battery side.

#SONY AUDIO TUNER FLASHING PROTECT PLUS#

Plus it has the extra benefit if you are watching tv or playing tunes when the power goes out, it keeps playing with the battery back up.

#SONY AUDIO TUNER FLASHING PROTECT SERIES#

I bought a CyberPower UPS voltage regulator for under $100 and no more protection error! I am so happy I did not take my unit in for servicing or throw it away since the ES Series is not cheap! That is what is tripping the switch in my ES Receiver. I know this because my computer is on a voltage regulator. Electricity seems to come to our house with spikes and drops. Our house does not receive a clean current. I have Bose Acoustimass speakers and they pass through the subwoofer where the subwoofer would terminate an error before it reaches my receiver so I know it's not my speakers or wires. I'm commenting because on my web search I came across this link and wanted to provide what solved my problem which was not listed. It's easy to forget that you need to set this. The receiver reset the speaker resistance setting to 8ohms (Perhaps from going into the protect mode or perhaps from a power outage). I recently had this happen where my Sony Receiver went into protect mode.

#SONY AUDIO TUNER FLASHING PROTECT MANUAL#

If you have a complex speaker setup then check your manual as to what setting you should use. If you have speakers under 8ohms resistance, you must reset the receiver using the TV menu, settings->speakers->resistance to 4ohms.

I've unplugged the unit and then plugged back in I've also checked the speaker connections and they are ok-not touching each other or the back of the receiver. Jcg our Sony STR-DE615 will go into protect mode after a few seconds or a few minutes of operation. We are going to replace our whole system in the next year meanwhile, is there any way to fix the problem now? I've read suggestions to take the back off the receiver and tighten all the screws/connections. The receiver first did this suddenly while watching TV, so I know that no speaker wires had been changed or moved around, but I checked just in case.

Our Sony STR-DE615 will go into protect mode after a few seconds or a few minutes of operation.

Sony audio tuner flashing protect